AnyTone MyAmplifiers V-15W Installation Manual - Page 14

Browse online or download pdf Installation Manual for Extender AnyTone MyAmplifiers V-15W. AnyTone MyAmplifiers V-15W 20 pages. Mobile signal repeater

Print Page

7.4. System Test

7.4.1. Check whether the coverage is good

1. Take a test with a mobile phone or a data card (engineering mobile phone is preferred).

To test signal level with a cell phone, make use of its engineering mode (Field Test

Mode), which is an application available in free access or a phone mode requiring no

extra setups. On most used mobile OS (operating systems) the test mode can be started

as follows:

◦ iOS. Type *3001#12345#* and hit Call

◦ Android. Type *#*#197328640#*#* to activate

◦ Windows. Type ##3282# and start.

◦ Blackberry. Press TOOLS, SETTINGS, STATUS or OPTIONS, STATUS.

Note! To get parameters for 2G, 3G and LTE, disable WiFi. In case you cannot find Field

Test Mode on your cell phone, use bars on the screen of your mobile phone to evaluate

the change.

If the signals in most areas have not been improved, please check recommendations below

again:

- Weak input signal leads to low output power. To increase input signal power level, change the

direction of the outdoor antenna or its installation position or replace it for an antenna with

higher gain.

- Check whether it is necessary to use additional indoor antennas as barriers block signal

penetration; also check whether the repeater's power is enough; please install extra indoor

antennas or replace the repeater for another model with higher power level.

2. If the signals in small parts of the area have not been improved, please check the following:

- Check whether the indoor antenna is installed correctly or not; you may try to change the

antenna location to improve coverage.

- Check if it is necessary to adjust the direction of the indoor antenna.

- Check whether it is necessary to add one or more antennas to enhance the coverage in special

areas.