Duerkopp Adler 195 Installation Manual - Page 8
Browse online or download pdf Installation Manual for Sewing Machine Duerkopp Adler 195. Duerkopp Adler 195 14 pages.
Also for Duerkopp Adler 195: Operating Instructions Manual (18 pages)
Print Page
4. Connecting the Sewing Drive to the Table Top.
4.1 General
4.2 Drive Mounting
4.3 Voltage Compensation Motor/ Machine Head
8
Different drive and connections packages are
available for the machine. The drive package
consists of:
Motor, motor protection switch with wiring, belt,
belt pulley.
The connections package contains all wiring
between the motor and the sewing head.
The direct current drive available for this machine
is operated by a "monophase alternating voltage".
Therefore, with multiple machines, the connections
must be uniformly distributed to the individual
phases of the mains supply (3 phase). Otherwise
this could lead to an overload of the individual
phases.
Attention!
If the electronics are not supplied by Dürkopp
Adler, then manufacture and testing is to be
conducted to
EN 60204-3-1/JEC 204-3-1.
–
Screw the drive with its base to the table top.
Hereby screw 3 M8 x 35 hex head screws with
washers into the nuts in the table top.
–
Fasten the V-belt pulley to the motor shaft.
–
Check the arrangement of the connections on
the motor terminal board and correct if
necessary.
The arrangement must be appropriate to the
mains voltage.
–
Screw the connecting cable found in the
enclosed package onto the motor base. It
serves to conduct the static charge of the
machine head to ground via the motor.