cascade corporation C Series Service Manual - Page 8

Browse online or download pdf Service Manual for Forklifts cascade corporation C Series. cascade corporation C Series 14 pages. Integral sideshifter
Also for cascade corporation C Series: User Manual (12 pages)

Print Page

ERVICE

Sideshifter Removal

4.1

NOTE: The following procedure describes removal of

the sideshifting frame only. To remove the cylinder, see

Section 4.3. To remove the integral sideshifting carriage

from the mast, refer to OEM Service Manual procedures.

Remove the forks and backrest from the sideshifter

frame. For Cascade backrest reassembly, tighten the

capscrews to 145 ft.-lbs. (195 Nm).

Remove the lower mounting hooks and inspect for wear.

For reassembly, adjust hooks as shown below and

tighten to 120 ft.-lbs. (162 Nm).

Install an M12 lifting eye in the center threaded hole in

the frame's top bar. Use a 1000 lb. (450 kg) capacity

overhead hoist and lift the frame away from the truck

carriage.

NOTE: Bearings and cylinder will remain on the integral

carriage bars.

For installation, reverse the above procedures with the

following exceptions:

• Clean and inspect carriage bars for damage and

smoothness. Make sure that bars are parallel and

that ends are flush.

• Clean all bearing areas of built-up dirt and grease.

• Inspect sideshifter bearings for wear and replace as

necessary. Refer to Section 4.2-2.

• Install and adjust lower hooks as shown below.

CAUTION: Lower hook clearance must be adjusted

as shown for proper sideshifter operation.

• Lubricate both upper and lower sideshifter bearings

with general-purpose chassis grease.

Lower

Front View

Mounting

Hooks

Lower

Mounting

Hooks

Mast

Carriage

Minimum

Wear

1.8125 in.

Limit

(46 mm)

Mark

SS0442.eps

SS0468.eps

Front Views

SS0448.eps

Lower Hook

Tighten capscrews to

120 ft.-lbs. (165 Nm)

Clearance:

1/32 in. (0.8 mm) Min.

1/16 in. (1.6 mm) Max.

Sideshifting

Frame

FRONT

SS0365.eps

6020275-R2