Duke FWM3-24-240 Operator's And Service Manual - Page 8
Browse online or download pdf Operator's And Service Manual for Commercial Food Equipment Duke FWM3-24-240. Duke FWM3-24-240 17 pages.
Print Page- 1. Table of Contents
- 2. Manufacturer's Introduction
- 3. Specification Sheet
- 4. Installation Instructions
- 5. Stacking Units
- 6. Unit to Unit Communication Connections
- 7. Periodic Maintenance, Checklist and Cleaning Guide
- 8. Troubleshooting
- 9. Electronic Control Fault Indications
- 10. Temperature Check Procedure
- 11. Control Programming
- 12. Parts Lists and Illustrations
- 13. Wiring Schematic
PRODUCT HOLDING UNIT
Unit to Unit Communication Connections
The following are the two different field connections, i.e. Specialty Board and Main Board.
Main Board Field Connection
The MB-1 Main Board Unit that has the ICC Black Box internally mounted can be identified as the warmer with
timer bars on both sides and plug connections numbered Warmer #2 and #3 as shown in Figure 2.1. This unit
is internally wired and ready to operate. Should your restaurant have two or more units on the main board the
second or third unit can be identified as the warmer with timer bars on each side and one plug connection as
shown in Figure 2.1. To put this second unit into operation connect the provided cable between the #2 plug
connection on the MB-1 and the single plug connection on the MB-2 unit. To put the third warmer into operation
connect the provided cable between the #3 plug connection on the MB1 and the single plug connection on the
MB2. The ICC steamer bar, if provided, plugs into the #3 plug connection on the MB1 unit as shown in figure
2.1. The program connection is used with the ICC provided Palm Pilot programming device.
Specialty Board Field Connection
The SB-1 Specialty Board Unit that has the ICC black box internally mounted can be identified as the warmer
with one timer bar and plug connections numbered Warmer #2 and #3 as shown in Figure 2.2. This unit is
internally wired and ready to operate. The SB-2 Specialty board Unit has one timer bar and one plug
connection as shown in Figure 2.2. To put this unit into operation connect the provided cable between the #2
plug connection on the SB-1 and the single plug connection on the SB-2 unit. The #3 plug on the SB1 is used if
a third SB2 warmer is added.. The program connection is used with the ICC provided Palm Pilot programming
device.
REVISED:
Feb. 21, 2005
Figure 2.1
Figure 2.2
U.S. Patent 6175099, 6262394
Other U.S. and Foreign Patents Pending
DUKE MANUFACTURING CO.
TOLL FREE 800-735-DUKE (3853)
314-231-1130
9 of 20
RESTAURANT
EQUIPMENT
MANUAL