Danfoss VACON 20 X Mounting Instructions - Page 3
Browse online or download pdf Mounting Instructions for DC Drives Danfoss VACON 20 X. Danfoss VACON 20 X 4 pages. Mains switch installation
Also for Danfoss VACON 20 X: Manual (4 pages)
Print Page
Vacon 20 X - Simple operator panel
• Connect the GROUND wire to the proper terminal (see the yellow-green cable
7
on Figure 3.
• Connect the cables from the potentiometer and from the selector to the I/O
8
control terminals. The cables have to be connected to the I/O terminals as
shown in the Figure 3 and in the Table 2.
• RED, BLUE and BLACK wires are signals from the potentiomenter.
9
• YELLOW, WHITE and GREY wires are signal from the selector switch.
10
Service support: find your nearest Vacon service center at www.vacon.com
Figure 3. Simple operator panel connected.
vacon • 3
1