Danfoss VACON 20 X Montaj Talimatları - Sayfa 3

DC Sürücüler Danfoss VACON 20 X için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. Danfoss VACON 20 X 4 sayfaları. Mains switch installation
Ayrıca Danfoss VACON 20 X için: Manuel (4 sayfalar)

Sayfayı Yazdır
Danfoss VACON 20 X Montaj Talimatları
Vacon 20 X - Simple operator panel
• Connect the GROUND wire to the proper terminal (see the yellow-green cable
7
on Figure 3.
• Connect the cables from the potentiometer and from the selector to the I/O
8
control terminals. The cables have to be connected to the I/O terminals as
shown in the Figure 3 and in the Table 2.
• RED, BLUE and BLACK wires are signals from the potentiomenter.
9
• YELLOW, WHITE and GREY wires are signal from the selector switch.
10
Service support: find your nearest Vacon service center at www.vacon.com
Figure 3. Simple operator panel connected.
vacon • 3
1