Dunavox DAUF-46.145DB Instruction Manual - Page 9
Browse online or download pdf Instruction Manual for Wine Cooler Dunavox DAUF-46.145DB. Dunavox DAUF-46.145DB 14 pages.
Print Page
WARNING!
Upper zone set temperature must be at least 3ºC
cooler than lower zone set temperature!
Note:
For the first time to use the appliance or to restart
the appliance after having been shut off for a long
time, you may find a few degrees variance between
the set temperature and the displayed temperature.
It will be normal after a few hours running.
SELECTING FAHRENHEIT(ºF) & CELSIUS
(ºC) DISPLAY
For Dual Zone
Directly touch the right mark
at the same time and hold for 3 seconds, you can
interchange the Fahrenheit and Celsius display for
both zones in the same time.
GENERAL INFORMATION
Operating Noises
The unit is cooled by a compressor (refrigeration
aggregate). The compressor pumps coolant through
the cooling system, producing operating noise. Even
when the compressor cuts out, noises caused by
changes
in
temperature
unavoidable. Operating noise will be most audible
immediately after the compressor cuts in. It becomes
quieter as the operating period continues.
The following noises are normal and occur from time
to time:
- Gurgling sound, caused by the refrigerant flowing
through the appliance's coils,
- Humming
noise
compressor.This noise can get louder for brief
periods when the motor is switching on.
- Cracking/popping sounds, resulting from the
materials contraction and expansion due to
temperature variations,
- Fan operating sound, to circulate the air within the
wine cabinet.
Unusual noise is normally the result of improper
installation. Under no circumstances must tubing
come into contact with a wall, other furniture or with
other tubing.
Where the unit is installed in open-plan kitchen or in
partition walls, the level of operating noise will be
heard more acutely. However, this is due to the
surrounding architecture and not to the unit.
An individual's perception of noise is directly linked to
the environment in which the unit is located, as well
the specific type of models. Our appliances are in
line with international standards for such appliance
and in line with the latest technical developments.
But please remember that the noise of the
and
with 2 fingers
and
pressure
made
by
the
motor
compressor and the coolant circulating in the system
is unavoidable.
DEFROSTING / HYGROMETRY /
VENTILATION
Your unit is designed with an automatic defrost
system. During the "Off-cycle" the evaporator behind
the rear wall of the unit defrosts automatically. The
condensate collects in the drain trough behind the
rear wall of the unit, and part of it flows through the
drainage hole into the drip tray by/above the
compressor. The heat is transferred from the
discharge pipe or compressor and evaporates any
condensation that has collected in the tray. Part of
the remaining water is collected within the unit for
humidity purposes.
This system enables the creation of the correct
humidity level inside your unit required by the natural
cork to maintain a long lasting seal.
The appliance is not totally sealed: Fresh air
admission is permitted through the drain pipe. Air is
circulated through the unit by means of a fan / fans
and the hollow shelves.
NOTE: Frost may be accumulated on the evaporator
if the unit is repeatedly opened in a high heat or high
humidity location. If this frost pattern does not clear
within 24 hours, your unit will require manual
defrosting.
are
CARE AND MAINTENANCE
WARNING: Failure to unplug the appliance during
service and cleaning could result in electrical shock
or other personal injury.
HUMIDITY CONTROL (Available for model
DX-104.375DB, DSS)
The appliance is equipped with a system for
maintaining the correct level of humidity. Under
extremely dry environmental conditions, you may
have to add some water into the humidity box
provided with your wine cellar.
Fill the small plastic reservoir (humidity box) ¾ full
with water, and fit onto the runners found on the top
shelf of the appliance.
regularly and refill as necessary.
Please ensure the reservoir is positioned correctly
on the runners on the top shelf to avoid the
possibility of water spillage.
Check the water level