Danfoss VLT AQUA Drive FC 202 Installation Manual - Page 2

Browse online or download pdf Installation Manual for Control Unit Danfoss VLT AQUA Drive FC 202. Danfoss VLT AQUA Drive FC 202 8 pages. Igbt module replacement for d1h–d8h drives
Also for Danfoss VLT AQUA Drive FC 202: Operating Manual (16 pages), Installation Manual (20 pages), Installation Instructions Manual (6 pages), Installation Manual (18 pages), Installation Instructions Manual (8 pages), Installation Instructions Manual (10 pages), Installation Manual (6 pages), Operating Instructions Manual (16 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (6 pages), Installation Manual (8 pages), Installation Manual (6 pages)

Print Page

Installation Guide | VLT® Wireless Communication Panel LCP 103

Compatible software versions:

•

VLT® HVAC Drive FC 102: 5.10

•

VLT® Refrigeration Drive FC 103: 2.10

•

VLT® AQUA Drive FC 202: 3.10

•

VLT® AutomationDrive FC 301/FC 302 and VLT® Lift Drive LD 302: 8.03

1.3 Approvals and Certifications

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by 1 or more

of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Modifications: Any modifications made to this device that are not approved by Danfoss may void the authority granted to

the user by the FCC to operate this equipment. RF EXPOSURE COMPLIANCE This portable transmitter with its antenna has

shown compliance with FCC's SAR limits for general population/uncontrolled exposure. The maximum listed SAR level is

0.22 W/kg (body). The antenna used for this device must not be co-located or operating along with any other antenna or

transmitter.

FCC ID: 2ANSELCP-103

N O T I C E

Introduction

AN331428064824en-000101 / 130R0814