Belden FX FUSION SC CONNECTOR Installation Manual - Page 6
Browse online or download pdf Installation Manual for Cables and connectors Belden FX FUSION SC CONNECTOR. Belden FX FUSION SC CONNECTOR 8 pages. 900μm tight buffer/250μm
Also for Belden FX FUSION SC CONNECTOR: Installation Manual (8 pages)
Print Page
12.
Place the cleaved fiber in the
V-groove (on the right side) of
the fusion splicer.
NOTE: The placement of the end face is
important. Fibers end face should be
located in between the V-groove and
electrodes as shown.
13.
Perform the fusion.
FX FUSION SC CONNECTOR
900µm TIGHT BUFFER/250µm - INSTALLATION GUIDE
14.
Bring the splice protection
sleeve close to the splicer.
15.
Open the splice holder and, by
holding the cable and the dust
cap, remove the spliced cable
assembly from the splicer.
PX106500-EN REV E
Page 6 of 8