Audioroot eSMART BC1150 Manual - Page 4

Browse online or download pdf Manual for Camera Accessories Audioroot eSMART BC1150. Audioroot eSMART BC1150 5 pages. 6 bay smart battery combiner/coupler in pc1150 with built-in 2 x 4a sequential charger and eink display

Print Page

4. Fan air outake

5. Display refresh button

6. eINK display

7. DC current output switch

8. Air intakes

9. USB mini port – for firmware upgrades

10. Legacy mode switch – set the switch to ON when using the BC1150 with a eSMART BG-DU or K-

ART

11. Soft reset – push this button to reset the internal microcontroller and eINK display.

OPERATION:

The eSMART BC1150 is fully plug'n'play. To install the batteries simply slide them into each one of

the 6 slots. Make sure that each battery is fully inserted. If not the lid of the Pelicase won't be able to

close properly. Batteries are held in place securely once the lid of the case has been closed. Spring

mounted stoppers allow the use of short (eSMART Li-48neo, Li-49Wh) or long (Li-96neo, Li-98Wh)

batteries. Short and long batteries can be used in any combination. The BC1150 can work with 1 to 6

batteries however current limitations may apply (see important note below).

Once a load is connected to DC OUT (#1) and if the switch (#7) is set to the ON position the

batteries will start to drain and power will be fed to the connected equipment.

IMPORTANT NOTE

with the highest charge level will start to drain first. All batteries will drain at the same rate and share the

load once they've reached even voltage/capacity levels. DC OUT can supply up to 11.5A of current if

enough batteries have the same charge level. If not DC OUT current will be limited by the specifications of

the battery with the highest charge level :

http://www.audioroot.fr [email protected]

: the 6 batteries share their power via OR'ing diodes. As a result the batteries

Ce document est la propriété d'AUDIOROOT, et ne peut-être reproduit ou communiqué sans autorisation