Duratool D01841 Instructions - Page 3
Browse online or download pdf Instructions for Rework stations Duratool D01841. Duratool D01841 3 pages. 240v hot air rework station
Also for Duratool D01841: Quick Manual (4 pages)
Print Page
ACCESSORY FITTING
•
Removing or fitting nozzles should only be done when the hot air tool is switched
off and at room temperature.
•
Do not use pliers to remove hot nozzles.
•
The nozzles are a firm slip on fit onto the output tube with additional locking screw.
•
Do not over tighten the screw.
•
Nozzles of different sizes are available, see our website or catalogue for details.
CLEANING
•
Cleaning should only be done when the heat gun is switched off and at room
temperature.
•
The hot air tool may be cleaned with a damp cloth and a small amount of liquid
detergent if necessary.
•
Do not use any chemicals, abrasives or solvents that could damage the casing.
SPECIFICATION
Voltage
Power
Sensor type
Air pump
Air temperature
Air Flow
Weight
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical
& Electronic Equipment (WEEE). Any WEEE marked products must not be mixed with
general household waste, but kept separate for the treatment, recovery and recycling of
the materials used. Contact your local authority for details of recycling schemes in your
area.
220-240V~50Hz
320W
K Thermocouple
Diaphragm type
o
160-480
C
24l/min (Max)
3.25kg
4
Made in China. PR2 9PP
Man Rev 2.0