Duratuf KIWI MK1A Assembly Instructions Manual - Page 13

Browse online or download pdf Assembly Instructions Manual for Outdoor Storage Duratuf KIWI MK1A. Duratuf KIWI MK1A 16 pages.

Print Page

MK1A BARGE & SPOUTING

Note: MK2 shown

Step 1: Position Barge Flashing (A102) on gable

ends. Position a Spouting (A103) and rivet

to the Barge Flashing at each end. Repeat

with other Spouting.

Step 1: Place shed in final position. Check the diagonal

measurements are the same and the shed is

level before fitting Floor. It is recommended that

the shed is anchored down with either a Duratuf

Bolt Down Kit or Duratuf Peg Down Kit depend-

ing on what the shed is sited on.

Step 2: Lay a Floor Board on top of Bottom Plates and

Joist and push up against end wall. Mark out

where Studs are. Cut checkouts with Electric

Jigsaw so Floor Board will fit around Studs.

Step 2: Centralise Barge Flashing on gable end

MK1A FLOOR

and rivet in place, one rivet into every

second Rib. Fit two rivets through top of

Barge into Rib. Repeat with other Barge

Flashing. Check Spoutings are straight,

then rivet to Roof one rivet every second

Rib.