4IPNET EAP210 Quick Installation Manual - Page 8

Browse online or download pdf Quick Installation Manual for Wireless Access Point 4IPNET EAP210. 4IPNET EAP210 15 pages. Enterprise access point
Also for 4IPNET EAP210: User Manual (20 pages)

Print Page

Hardware Installation

Please follow the steps mentioned below to install the hardware of EAP210:

1. Place the EAP210 at the best location.

The best location for EAP210 is usually at the center of your intended wireless network.

2. Connect EAP210 to your network device.

Connect one end of the Ethernet cable to the Uplink port of EAP210 and the other end of the cable to a

switch, a router or a hub. EAP210 is then connected to your existing wired LAN network.

3. There are two ways to supply power over to EAP210.

(a) Connect the DC power adapter to the EAP210 power socket.

Please use only the power adapter supplied with the EAP210 package. Using a different power

adapter may damage this system.

(b) EAP210 Uplink port is capable of receiving DC currents. Connect an IEEE 802.3af-compliant PSE

device, e.g. a PoE-switch, to the Uplink port of EAP210 with the Ethernet cable.

Now, the Hardware Installation is completed.

To verify the wired connection between EAP210 and your switch/router/hub, please check the

LED status indication of these network devices.

EAP210 Enterprise Access Point

Quick Installation Guide

ENGLISH