Elsema Gigalink GLR43308 Setup And Programming Instructions - Page 4

Browse online or download pdf Setup And Programming Instructions for Receiver Elsema Gigalink GLR43308. Elsema Gigalink GLR43308 8 pages. 8 channel receiver

Print Page

PROGRAMMING INSTRUCTIONS

The transmitter and receiver can be multi or single channel programmed.

Multi-channel Programming

This is used to program all channels from a multi-channel receiver to a multi-channel transmitter. Multi-

channel programming can be achieved by following the steps below:

Step 1:

Connect power to the GIGALINK

dipswitch are off.

Step 2:

Momentarily short the two CC pins on the receiver board. This sets all the channels

to a random code. If there are transmitters previously programmed, they will have to

be re-programmed when CC pins are shorted. Do not do this step if you want to

keep previously programmed transmitters.

Step 3:

Connect the multi-channel transmitter to the multi-channel receiver by inserting the

GIGALINK

will activate the programming mode and is indicated by the red light (LED), on the

transmitter that must remain "on").

Step 4:

Activate any two channels simultaneously on the multi-channel transmitter for

one second, LED should blink twice to conﬁrm code programming and then switch

"off".

Step 5:

Disconnect GIGALINK

Repeat steps 3 to 5 to program another multi-channel transmitter.

If you are programming another transmitter, do not short out the CC pins. Shorting out the CC pins

will delete all previously programmed transmitters.

receiver. Make sure all switches on the mode

™

cable into the transmitters and receivers 2.5-mm Coding socket. (This

™

cable.

™

For detailed information visit www.elsema.com