Dataprobe IP-410 - Manual - Page 12

Browse online or download pdf Manual for Switch Dataprobe IP-410 -. Dataprobe IP-410 - 17 pages. Web controlled power switches

Print Page
iPAL

Telnet Operation

Access for operation via telnet is the same as access for configuration.
Location
Mode = 6
1.
Outlet 1
2.
Outlet 2
3.
Outlet 3
4.
Outlet 4
5.
Outlet 5
6.
Outlet 6
7.
Outlet 7
8.
Outlet 8
#
- Select relay to toggle or A for All
P# - Pulse relay
S
- Setup
X
- Exit
Enter >
The screen shows the current status of all power outlets.
To change the status of any outlet, type the outlet number and <Enter> at the prompt.
You can change all circuits simultaneously by selecting A and <Enter> for All.
The feedback column confirms that the switch command you selected has been carried out. If this column reads "ERROR"
check the unit or the external cables to any expansion unit. Switching outlets 5-8 without an attached power switch will cause
this error.
To momentarily pulse (cycle) the status of an outlet, for power reboot, enter P and the outlet number plus <Enter> The status
will change while the outlet is cycling. The duration of the pulse is determined in the setup. The default is 10 seconds.
All circuits can simultaneously be cycled by selecting PA <Enter>.
Status
Feedback
ON
OK
ON
OK
ON
OK
ON
OK
ON
OK
ON
OK
ON
OK
ON
OK
Page 12