Dataprobe MP-420 Quick Start Manual - Page 6
Browse online or download pdf Quick Start Manual for Network Hardware Dataprobe MP-420. Dataprobe MP-420 8 pages. Tone controlled power strip with multipal voice response
Models MP-415, MP-420
MULTIPAL OPERATING COMMANDS
After MP-415 has answered a call, and depending on the answer and security mode previously selected,
the following commands may be entered to operate MP-415.
1- 8 Report Status of an Outlet
MP-415 will report 'ON' or 'OFF' as indicated by the current outlet status. MP-415 will also report
'ERROR' if the controller cannot set the switch into the desired position. Once an outlet is
selected, it can then be changed by entering a # or « to toggle or pulse.
#
Change Status of an Outlet
MP-415 will toggle the currently selected (or all if 9 is used) outlet and report the new status.
«
Reset an Outlet
The MP-415 will pulse the outlet for the number of seconds determined by the Reset Time setting
9
Report Status of All Outlets
MP-415 will read off the status of all outlets. The number of outlets reported is controlled by the
Active Ports setting.
91
Turn All Outlets On
MP-415 will turn all active outlets On, then read off the status of all outlets.
92
Turn All Outlets Off
MP-415 will turn all active outlets Off, then read off the status of all outlets.
0
Ring Extension
MP-415 will ring the EXT port. No additional switch commands will be accepted by MP-415
Example:
You Send
«
MP-415 Does This
1
#
Turn off Outlet 1 " 1 OFF "
3
Turn Off Outlet 3
Wait (Reset Time)
Turn On Outlet 3
91
Turn On All Outlets
MP-415 Says This
" 1 ON "
" 3 ON "
" 3 OFF Reset "
" 3 ON Reset "
" 1 On, 2 On......"
Page 6