Dataprobe MP-420 Manual de inicio rápido - Página 6

Navegue en línea o descargue pdf Manual de inicio rápido para Hardware de red Dataprobe MP-420. Dataprobe MP-420 8 páginas. Tone controlled power strip with multipal voice response

Imprimir página

Models MP-415, MP-420

MULTIPAL OPERATING COMMANDS

After MP-415 has answered a call, and depending on the answer and security mode previously selected,

the following commands may be entered to operate MP-415.

1- 8 Report Status of an Outlet

MP-415 will report 'ON' or 'OFF' as indicated by the current outlet status. MP-415 will also report

'ERROR' if the controller cannot set the switch into the desired position. Once an outlet is

selected, it can then be changed by entering a # or « to toggle or pulse.

Change Status of an Outlet

MP-415 will toggle the currently selected (or all if 9 is used) outlet and report the new status.

Reset an Outlet

The MP-415 will pulse the outlet for the number of seconds determined by the Reset Time setting

Report Status of All Outlets

MP-415 will read off the status of all outlets. The number of outlets reported is controlled by the

Active Ports setting.

Turn All Outlets On

MP-415 will turn all active outlets On, then read off the status of all outlets.

Turn All Outlets Off

MP-415 will turn all active outlets Off, then read off the status of all outlets.

Ring Extension

MP-415 will ring the EXT port. No additional switch commands will be accepted by MP-415

Example:

You Send

MP-415 Does This

Turn off Outlet 1 " 1 OFF "

Turn Off Outlet 3

Wait (Reset Time)

Turn On Outlet 3

Turn On All Outlets

MP-415 Says This

" 1 ON "

" 3 ON "

" 3 OFF Reset "

" 3 ON Reset "

" 1 On, 2 On......"

Page 6