Dux Platinum 3000 Series Product Manual - Page 4
Browse online or download pdf Product Manual for Power Tool Dux Platinum 3000 Series. Dux Platinum 3000 Series 20 pages. Pressure feed
Print PageCoatings and solvents may be extremely flammable or combustible. Always use
the equipment in a properly ventilated area. Smoking must never be permitted in
the spraying area. Make sure that all ignition sources are well out of range and
always keep fire extinguishing equipment in the spraying area.
Some solvents may cause eye injury during operation and/or while cleaning the
equipment. Always wear eye protection when working with the equipment.
NEVER USE HALOGENATED HYDROCARBON SOLVENTS in or on this equip-
ment. They can adversely react with aluminum and cause fire and/or explosion.
These materials include but are not limited to, 1-1-1 Trichloroethane, Methylene
Chloride, Dichloromethane, and Carbon Tetrachloride.
Some coatings and solvents may be harmful if there is contact with the skin or if
inhaled. Always make sure to read the MSDS supplied by the material manufac-
turer. Always use the equipment in a properly ventilated area. If there is a chance
of inhalation or contact with skin, use protective gear such as a respirator and/or
proper clothing as suggested by the MSDS.
Required Maintenance
•
Clean equipment after each use
•
Lubricate spray gun before each use and/or after every cleaning
•
Do not submerge spray gun in solvent
•
Ensure proper handling of the gun at all times - damage due to dropping or
mishandling of the spray gun is not covered by the warranty
•
Ensure air and fluid hoses are properly connected
•
Do not apply air or fluid pressures above the maximum published inlet pressure
•
Problems resulting from any of the above-mentioned situations will jeopardize
warranty
Platinum Pressure Feed Safety Information
•
Use the equipment only for its intended purpose
•
Do not point spray gun at any part of body or place hands or fingers over spray tip
•
Inspect equipment for physical damage or loose fittings before each use
•
Shut off air and remove coating supply to spray gun before servicing
•
Use fluids and solvents that are compatible with equipment wetted parts
•
Do not use with improperly operating equipment
•
Always refer to the owner's manual for proper operating instructions
•
Comply with all applicable safety regulations
•
Read all instruction manuals, tags, and labels before operating the equipment
•
Always read the MSDS supplied by the material manufacturer
•
Do not exceed 75psi/5.17 bar air or fluid inlet pressure
•
Equipment is not intended to be used with oxidizing materials
•
Do not use equipment in ambient temperatures greater than 40º C/104º F or less than 0º C/32º F
•
Always properly discharge static electricity prior to operating the equipment
•
Anti-static hoses must be used in potentially explosive atmospheres.
•
Always properly ground spray target and spray gun prior to use.
For customer service call 888.389.2732
PLATINUM PRESSURE FEED
WARNINGS
Safety
Page 4