Agri-Fab 45-02102-101 Owner's Manual - Page 8
Browse online or download pdf Owner's Manual for Spreader Agri-Fab 45-02102-101. Agri-Fab 45-02102-101 16 pages. 125 lb. push broadcast spreader
Also for Agri-Fab 45-02102-101: Owner's Manual (16 pages)
Print Page24. Attach an angle stop bracket and a swivel bracket
to the rear hole in the R.H. shield bracket using
a 1/4" x 3/4" hex bolt, two 5/16" washers, a ny-
lon washer and a 1/4" hex lock nut. Place the
angle stop bracket on the inside and the swivel
bracket on the outside. Tighten the locknut so
that the swivel bracket can pivot freely. See fig-
ure 13. Repeat step on L.H. shield bracket.
25. Attach a swivel bracket to the front hole in the
R.H. shield bracket using a 1/4" x 3/4" hex bolt,
two 5/16" washers, a nylon washer and a 1/4"
hex lock nut. Tighten the locknut so that the
swivel bracket can pivot freely. See figure 13.
Repeat step on L.H. shield bracket.
5/16"
WASHER
1/4" HEX
LOCK NUT
ANGLE STOP
BRACKET
FIGURE 13
1/4" x 3/4"
HEX BOLT
NYLON
WASHER
NYLON
WASHER
SHIELD
BRACKET
SWIVEL
BRACKET
26. Assemble the spreader shield to the front swivel
brackets using two 1/4" x 3/4" carriage bolts, 5/16"
washers and the two 1/4" plastic knobs. See figure
14.
27. Assemble the spreader shield to the rear swivel
brackets using two 1/4" x 3/4" hex bolts, four 5/16"
washers and two 1/4" hex lock nuts. Tighten the
locknuts so that the swivel bracket can still pivot
freely. See figure 14.
5/16" WASHER
1/4" LOCK NUT
FIGURE 14
28. Place the hopper screen down into the hopper
to help break up clumpy material and to prevent
large clumps from reaching the bottom of the
hopper and clogging the opening. See figure 15.
FIGURE 15
8
PLASTIC
KNOB
1/4" x 3/4"
HEX BOLT
1/4" x 3/4"
CARRIAGE BOLT
HOPPER SCREEN