DVIGear DVI-3580a Quick Start Manual - Page 3

Browse online or download pdf Quick Start Manual for Switch DVIGear DVI-3580a. DVIGear DVI-3580a 9 pages. 4k multiviewer switcher, scaler
Also for DVIGear DVI-3580a: Quick Start Manual (8 pages)

Print Page

4K MultiViewer Switcher / Scaler

Installation

1.)

Rack Mount Ears and Removable Feet:

Add or remove these accessories as needed.

2.)

Video Sources and Destinations:

Connect each video source device to

the HDMI, DisplayPort or VGA inputs

on the rear of the DVI-3580a as

needed. Next, connect the displays or

downstream devices to the HDMI output

and/or the HDBaseT output. The HDBaseT

output only supports extension of audio, video, and POH. The RS-232, LAN, and IR signals cannot

be extended over the link. DVIGear

grade cable for the HDBaseT link.

3.)

Audio Sources and Destinations:

jacks accompanying the appropriate video signals as needed. Next, connect any downstream

audio devices to the appropriate audio outputs as needed.

4.)

Control Connections:

(built-in Web GUI or Telnet), RS-232, IR Remote Control, and Front Panel selections. The most

intuitive, versatile control method is the built-in Web GUI (see page 7).

To control the unit via the

standard (straight-through) LAN cable. Set the IP address of the control PC to be within the

same subnet as the unit. Next, open a web browser and input the IP address of the unit. By

default, the unit has an IP address of

To view the current IP address at any time, press and hold the Audio Source Button on the front

panel or IR remote for 5 seconds and the current IP will be displayed on the screen.

To control the unit via the

Default values:

5.)

Power:

First, supply power to the

Next, supply power to the DVI-3580a. To do this, plug the AC Power Cord into the receptacle

on the unit and then into an outlet. Switch the unit ON using the master switch on the rear of

the unit. This switch, along with the red power LED on the front panel, will remain illuminated

when power is supplied to the unit and the master switch is turned ON. The unit may need to be

toggled out of standby mode. When the unit is in standby, the standby button on the front panel will

light up green. Pressing this button will bring the unit out of standby.

After the unit is powered ON and is out of standby mode, supply power to the

Note 2 – WARNING: The HDBaseT port is designed to connect to compatible DVIGear products only (e.g. DVI-7520-RX).

Do not connect any device to the HDBaseT port of this product unless you are sure it is compatible. Do not connect any

HDBaseT device to the LAN port of the DVI-3580a. Connecting incompatible devices may cause harm to the devices.

Please use the preferred cable termination scheme (T568B) for all HDBaseT connections throughout the installation (see

the User Manual for more information). It is typical for HDBaseT receivers to operate at high temperatures. Care must

be taken to ensure airflow through the Rx unit is not restricted in any way.

recommends using CAT6A S/FTP (500 MHz) 23AWG high-

See the warning below.

Connect any external audio sources to the 3.5mm mini-

The unit may be controlled via a variety of options, including LAN

LAN

port, connect it to the network or directly to a PC using a

RS-232

port, connect to the unit using a straight-through cable.

baud rate: 9600; data bits: 8; stop bits: 1; parity: none; flow control: none.

destination

Quick Start Guide

(2)

192.168.100.100

and DHCP Mode disabled.

devices.

DVI-3580a

source

devices.