4RF Aprisa SRi Quick Start Manual - Page 8
Browse online or download pdf Quick Start Manual for Network Router 4RF Aprisa SRi. 4RF Aprisa SRi 12 pages.
Print Page
Page 8
Setup the Aprisa SRi Radio
3.
The Aprisa SRi has a factory default 'Terminal Operating
Mode' of Remote Station.
One radio in the Aprisa SRi network must be setup as a Base
Station.
The other radios in the Aprisa SRi network are setup as
Remote Stations.
Set the required 'Ethernet Operating Mode'.
Set the unique radio 'Base Station ID' to be the same in your
entire network. Every base station and it's attached
remote radios (i.e. base station network) shall have a
unique 'Base station ID' in case of close proximity or close
coverage between two or more base station networks.
Set the Aprisa SRi TX Power and Channel Size to comply
with your site license.
Setup the Aprisa SRi Zones / Channels.
Specific channels within the selected zone hop can be
disabled if there is a known transmission within the channel
that may cause interference to the operation of this
network. The minimum number of enabled channels is 50.
If a channel is selected in a zone that is disabled, the zone
will be enabled when the channel selection is saved. The
default is all zones enabled.
The zone frequencies are pre-defined in the Aprisa SRi for
the zone number. The zone frequencies are spaced at the
hop frequency of 62.5 kHz.
You can now configure the remaining terminal and network parameters and settings. Please refer to the Aprisa SRi User Manual
for detailed instructions, such as the radio security settings and more.