4RF Aprisa SRi Skrócona instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Router sieciowy 4RF Aprisa SRi. 4RF Aprisa SRi 12 stron.

Page 8

Setup the Aprisa SRi Radio

The Aprisa SRi has a factory default 'Terminal Operating

Mode' of Remote Station.

One radio in the Aprisa SRi network must be setup as a Base

Station.

The other radios in the Aprisa SRi network are setup as

Remote Stations.

Set the required 'Ethernet Operating Mode'.

Set the unique radio 'Base Station ID' to be the same in your

entire network. Every base station and it's attached

remote radios (i.e. base station network) shall have a

unique 'Base station ID' in case of close proximity or close

coverage between two or more base station networks.

Set the Aprisa SRi TX Power and Channel Size to comply

with your site license.

Setup the Aprisa SRi Zones / Channels.

Specific channels within the selected zone hop can be

disabled if there is a known transmission within the channel

that may cause interference to the operation of this

network. The minimum number of enabled channels is 50.

If a channel is selected in a zone that is disabled, the zone

will be enabled when the channel selection is saved. The

default is all zones enabled.

The zone frequencies are pre-defined in the Aprisa SRi for

the zone number. The zone frequencies are spaced at the

hop frequency of 62.5 kHz.

You can now configure the remaining terminal and network parameters and settings. Please refer to the Aprisa SRi User Manual

for detailed instructions, such as the radio security settings and more.