4tech MiniCom Guardian Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for Measuring Instruments 4tech MiniCom Guardian. 4tech MiniCom Guardian 4 pages. Monitoring system

Print Page

Temperature

Humidity

Power supply

Installation

Install the Guardian control unit in a dry indoor

environment.

1. Remove the front cover, and insert the SIM card

into your Guardian control unit (located in the

battery compartment).

2. Make sure the SIM-lid is properly mounted. (Slide

forward and you should hear a click.)

3. Mount the battery plug, and fit the battery into the

slot.

4. Mount the DIN rail with screws or two folded tapes

where you decide to mount your Guardian.

5. Mount your Guardian control unit onto the DIN rail

6. Mount the sensor (The blue box) at the location to

be monitored.

7. Attach the sensor to the Guardian control unit in

the left hand socket by using the blue CAT5 patch

cable.

8. Connect the power supply to the right hand socket

of the Guardian. Important: Connect your

Guardian to the same power outlet as your UPS or

server is connected to.

Enter PIN code

When the Guardian is first started with a SIM-card, and

the PIN code is enabled, it will ask for a PIN code

with a sequence of audio signals. (PIN code is only

requested for the first start up)

Enter the pin code using the red button. Each digit

is entered by pressing the button the corresponding

number of times (1= 1 push, 5= 5 pushes and

0= 10 pushes). Each digit will be repeated from

Guardian before the next digit can be registered.

Please note: If you make a mistake, wait until you get

the same sequence of signals and start again.

Please note: If you enter the wrong PIN code three

times, and have to enter PUK code, we recommend

to insert the SIM card in your mobile phone to enter

the PUK-code.

3 Configuration

Before you start to configure your Guardian we

suggest that you register the telephone number and

serial number. (The telephone number is identified by

your SIM-card, and the serial number is located on a

label on the back side of your Guardian)

Monitoring

Slide until you hear

the "click"

CAT5 Patch

Power