4tech MiniCom Guardian Hızlı Başlangıç Kılavuzu - Sayfa 2

Ölçüm Cihazları 4tech MiniCom Guardian için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. 4tech MiniCom Guardian 4 sayfaları. Monitoring system

Temperature
Humidity
Power supply
1
Installation
Install the Guardian control unit in a dry indoor
environment.
1. Remove the front cover, and insert the SIM card
into your Guardian control unit (located in the
battery compartment).
2. Make sure the SIM-lid is properly mounted. (Slide
forward and you should hear a click.)
3. Mount the battery plug, and fit the battery into the
slot.
4. Mount the DIN rail with screws or two folded tapes
where you decide to mount your Guardian.
5. Mount your Guardian control unit onto the DIN rail
6. Mount the sensor (The blue box) at the location to
be monitored.
7. Attach the sensor to the Guardian control unit in
the left hand socket by using the blue CAT5 patch
cable.
8. Connect the power supply to the right hand socket
of the Guardian. Important: Connect your
Guardian to the same power outlet as your UPS or
server is connected to.
server is connected to.
Enter PIN code
2
When the Guardian is first started with a SIM-card, and
the PIN code is enabled, it will ask for a PIN code
with a sequence of audio signals. (PIN code is only
requested for the first start up)
Enter the pin code using the red button. Each digit
is entered by pressing the button the corresponding
number of times (1= 1 push, 5= 5 pushes and
0= 10 pushes). Each digit will be repeated from
Guardian before the next digit can be registered.
Please note: If you make a mistake, wait until you get
the same sequence of signals and start again.
Please note: If you enter the wrong PIN code three
times, and have to enter PUK code, we recommend
to insert the SIM card in your mobile phone to enter
the PUK-code.
3 Configuration
Before you start to configure your Guardian we
suggest that you register the telephone number and
serial number. (The telephone number is identified by
your SIM-card, and the serial number is located on a
label on the back side of your Guardian)
Monitoring
®
Slide until you hear
the "click"
CAT5 Patch
Power