dymax 39380 Operation Manual - Page 13

Browse online or download pdf Operation Manual for Industrial Equipment dymax 39380. dymax 39380 16 pages. Uv light-curing conveyors – 18" and 25"

Print Page

TROUBLESHOOTING

WARNING:

Only qualified maintenance personnel should attempt the following procedures:

Problem

Possible Cause

Main Line Circuit Breaker

tripped.

Improperly fastened

Connections.

Fuses for Motor

Controller blown.

Conveyor Not

Operating

Belt is hung up.

Tension too low on Belt

(Power Switch lights and

Motor turns but Belt does

not move).

Belt Tracks to

Belt Adjustment Screws

One Side

are out of position.

SPARE/REPLACEMENT PARTS

Part #

Part Description

40671

Conveyor Belt Guide

39376

18" Metal Halide Bulb (standard)

39613

18" Mercury Bulb

40672

Reflector for 18" Conveyor

39661

Conveyor Belt for 18" Conveyor

39373

25" Metal Halide Bulb (standard)

39614

25" Mercury Bulb

40673

Reflector for 25" Conveyor

39663

Conveyor Belt for 25" Conveyor

Dymax WIDECURE UV Conveyor

Testing

Toggle Power Switch off,

then on.

Check all connections.

Remove Fuses from Fuse

Holders (located in the left side

of control box of unit) and

check with an Ohmmeter.

Inspect the Belt for any signs

of a mechanical bind.

Verify the operation of the

Drive Shaft and Drive Rollers.

Visually inspect the Belt. The

Belt will track to one side.

Corrective Action

Find cause of tripped breaker.

Properly fasten connections.

Replace Fuses if defective.

Resolve bind and continue

operation.

Use the tracking adjustment

screws to increase the tension

on the Belt. Both knobs need to

be turned the same amount to

maintain alignment.

Tighten the Belt Adjustment

Screw (the one located on the

side to which the Belt is

tracking towards) until Belt

tracks straight. Only minor

adjustments should be made at

one time.