dymax Tridak 1001 User Manual - Page 16

Browse online or download pdf User Manual for Industrial Equipment dymax Tridak 1001. dymax Tridak 1001 20 pages. Syringe filling system

Print Page

Tridak® Model 1001 Syringe Filling System User Guide

4. Twist or slide the Syringe and Piston or extended Plunger on to the Nozzle/Needle/Luer-Lock Tip of

the Fluid Path.

5. Loosen the Syringe Fill Adjustment Lock by loosening the bottom two Allen Cap Screws (Figure 10).

6. Press and release the Foot Switch to extend the fill stop cylinder.

7. Move the Syringe Fill Stop to the position where it immediately touches the extended Syringe Plunger

or Syringe Piston.

8. Re-tighten the Syringe Fill Stop using Allen Cap Screws.

9. Press the Cylinder Retract switch to reset the system.

10. Connect the Compressed Air Supply from the Material Reservoir.

Figure 10. Model 1001 with Syringe Inserted

Luer Tip

Syringe

Piston

Priming the System

During initial setup and when changing material cartridge reservoirs, air must be purged from the disposable

fluid path/fill tube to prevent accidental spills and introducing bubbles into syringes. Prime the system by

running material through the fluid path until a constant, solid flow of material is achieved. Depending on

material, reducing the pressure by 5-15 psi will make it easier to see the air being purged.

Before filling each syringe, ensure the syringe plunger is fully inserted to the tip of the syringe to remove most

of the air from the empty syringe.

Syringe

Syringe Rest

Base Screw

Syringe Rest

Syringe

Set Screw

Rest

Syringe

Plunger

Fill Stop

Syringe Rest

Base

Allen Cap Screws