5Gstore EZ-62B Setup Manual - Page 2

Browse online or download pdf Setup Manual for Switch 5Gstore EZ-62B. 5Gstore EZ-62B 15 pages. Single outlet remote power switch

Print Page
IN
CL
AR

Setting up your Device

1. Connect an Ethernet cable from LAN port on your router to the EZ-62B.
2. Connect the power plug from the EZ-62B to a wall outlet. Once the system boots
up, the Output and Internet LEDs will turn ON.
3. Connect the power supply of the device you wish to reboot to the Outlet on the
EZ-62B. *If using a modem or router, allow time for the device to reboot and
reconnect to the Internet.
4. Press the Function button 1x to Enable the Auto Reset - the EZ-62B is now
ready to monitor your Internet and reset the outlet upon loss of connection. If you
wish to monitor the connection of your EZ-62B remotely and/or would like to
reconfigure the settings, including manual control for a LAN device, proceed to
the Cloud4UIS (cloud service) setup.
Adding EZ-62B to Cloud Service:
With an Internet connection, the EZ-62B can be controlled at any time, from anywhere
in the world using the website Cloud4UIS.com as well as the free mobile app ezDevice
( available on the App Store and Google Play Store ). **You'll notice there is a QR Code
on the bottom of your EZ-62B. This is a means of easily getting to the Cloud4UIS.com
site. There is NO option at this time to scan the QR Code and automatically add your
device, you will need to proceed with the instructions below.
1. Download and install ezDevice OR go to Cloud4UIS.com
2. You will be prompted to Sign Up for a Cloud4UIS account. Follow the
instructions on screen to complete this. You will also receive an email to verify
the account; after which you will then log in
LED Status
Both BLINKING until
Function button is
released
Both BLINKING
BLINKING in
sequence
DESCRIPTION
Reset device to Factory Default settings &
clears cloud linkage.
Firmware upgrading. Do NOT interrupt or
power off.
Device is in ADD mode. Required for 'Add
by Serial Number' function.