5Gstore EZ-62B Installatiehandleiding - Pagina 2

Blader online of download pdf Installatiehandleiding voor {categorie_naam} 5Gstore EZ-62B. 5Gstore EZ-62B 15 pagina's. Single outlet remote power switch

Pagina afdrukken

Setting up your Device

1. Connect an Ethernet cable from LAN port on your router to the EZ-62B.

2. Connect the power plug from the EZ-62B to a wall outlet. Once the system boots

up, the Output and Internet LEDs will turn ON.

3. Connect the power supply of the device you wish to reboot to the Outlet on the

EZ-62B. *If using a modem or router, allow time for the device to reboot and

reconnect to the Internet.

4. Press the Function button 1x to Enable the Auto Reset - the EZ-62B is now

ready to monitor your Internet and reset the outlet upon loss of connection. If you

wish to monitor the connection of your EZ-62B remotely and/or would like to

reconfigure the settings, including manual control for a LAN device, proceed to

the Cloud4UIS (cloud service) setup.

Adding EZ-62B to Cloud Service:

With an Internet connection, the EZ-62B can be controlled at any time, from anywhere

in the world using the website Cloud4UIS.com as well as the free mobile app ezDevice

( available on the App Store and Google Play Store ). **You'll notice there is a QR Code

on the bottom of your EZ-62B. This is a means of easily getting to the Cloud4UIS.com

site. There is NO option at this time to scan the QR Code and automatically add your

device, you will need to proceed with the instructions below.

1. Download and install ezDevice OR go to Cloud4UIS.com

2. You will be prompted to Sign Up for a Cloud4UIS account. Follow the

instructions on screen to complete this. You will also receive an email to verify

the account; after which you will then log in

LED Status

Both BLINKING until

Function button is

released

Both BLINKING

BLINKING in

sequence

DESCRIPTION

Reset device to Factory Default settings &

clears cloud linkage.

Firmware upgrading. Do NOT interrupt or

power off.

Device is in ADD mode. Required for 'Add

by Serial Number' function.