ADEMCO 4110DL Installation Instructions Manual - Page 8

Browse online or download pdf Installation Instructions Manual for Security System ADEMCO 4110DL. ADEMCO 4110DL 16 pages.

Print Page

SYSTEM INSTALLATION AND WIRING

––––––––––––––––––––––––– INSTALLING THE SYSTEM –––––––––––––––––––––––

Refer to the Summary of Connections diagram on the inside back cover of this manual for terminal

connections when following these procedures.

1. Mount the Control Cabinet.

2. Mount the PC board.

WARNING

3. Install Remote Keypads.

4. Install Hardwired Zones.

5. Install Sounding Devices.

U L

6. Install the Remote Keyswitch.

7. Connect Telephone Line.

IMPORTANT

8. Connect the AC Transformer.

WARNING

9. Connect the Battery.

IMPORTANT

U L

11.

Connect Earth Ground.

Section 2.

BE SURE TO USE THE PLASTIC MOUNTING CLIPS (SUPPLIED) TO

ISOLATE THE CIRCUIT BOARDS FROM THE CABINET. FAILURE

TO DO SO MAY RESULT IN DAMAGE TO THE TRANSFORMER

AND/OR THE CIRCUIT BOARDS.

Use only UL Listed sounding devices for UL installations.

Make sure telephones on the premises are connected only through the

alarm control panel (disconnect from the incoming phone line at the

telephone jack). This is necessary to have true line seizure.

DO NOT PLUG THE TRANSFORMER INTO THE AC OUTLET UNTIL

ALL OTHER WIRING TO THE CONTROL IS COMPLETE.

Do not attach the connector cable to the battery's terminals until

after you have plugged the AC transformer into an uninterrupted

120VAC outlet.

1. In UL installations, maximum current draw from the Auxiliary

Output and the Alarm Output combined must not exceed 500mA.

2. Use a 3A battery or larger for UL installations.

-8-