GREAT PLANES Mini Slinger Instruction Manual - Page 5

Browse online or download pdf Instruction Manual for Toy GREAT PLANES Mini Slinger. GREAT PLANES Mini Slinger 12 pages.

Print Page

BUILDING INSTRUCTIONS

❏

1. Locate the channels in each wing half that contain the

servo wire draw strings.

❏

2. Being careful not to sever the strings, cut away just

enough foam above these channels at the wing roots to

accommodate the thickness of the servo wires.

❏

3. Cut off three arms from (2) four-arm servo horns, leaving

one of the long arms intact as shown.

❏

4. Cut off the mounting tabs from the servo cases.

❏

5. Temporarily connect the servos to your radio system.

Turn the transmitter on and center your trim levers. With the

radio on, position the arms perpendicular to the servos. Make

a left and a right servo. If the servo model you are using has

the servo lead exiting from the side of the servo case as

shown in the picture above, use a hobby knife to remove

material from the servo bay in the wing until it fits properly.

❏

6. Use the strings to pull the servo leads through the

wing panels.

❏

7. Use epoxy to glue the servos into the servo bays. If you

would like the servos to be easily removable from the Mini

Slinger in the future, cover the servos in heat-shrink wrap

(TRIC6074) prior to gluing.You will then be able to cut the heat-

shrink to extract the servos from the wing with little damage.