GREAT PLANES Mini Slinger Instruction Manual - Page 6

Browse online or download pdf Instruction Manual for Toy GREAT PLANES Mini Slinger. GREAT PLANES Mini Slinger 12 pages.

Print Page

Join the Wing Halves

❏

1. Test fit the wing halves together with the carbon wing

joiner rods, with the long rod (500 mm [19-5/8"]) in the rear

and the short rod (225 mm [8-7/8"]) in the front. If the rods

prevent the wing halves from mating together, cut or sand

the rods as necessary until a good fit is achieved. When

satisfied, lightly coat one half of each rod with epoxy and

insert them into a wing half. With rubbing alcohol, wipe away

any excess epoxy that collects on the root of the wing half.

❏

2. When the epoxy has cured, mix another batch and

coat the other ends of the carbon tubes and the roots of the

wing panels. Slide the panels together making sure the

servo leads exit on top of the wing and use tape to hold them

tight while the epoxy cures. Wipe away any excess epoxy

that squeezes out.

❏

1. Measure 16 mm [5/8"] from the inside edge of each

elevon and make a mark as shown in the picture.

❏

2. Cut a 6 mm [1/4"] slot 8 mm [5/16"] aft of the hinge line

for the control horns. Make the cuts so that the control

horns will be parallel with the servo arms.

❏

3. Push the control horns through the cuts you made in

the elevons. Press a control horn backing plate onto the

underside of each control horn. Secure the backing plates

and control horns to the elevons with foam safe CA glue.