GREAT PLANES Riot 3D Instruction Manual - Page 9
Browse online or download pdf Instruction Manual for Toy GREAT PLANES Riot 3D. GREAT PLANES Riot 3D 20 pages.
Print Page
RADIO SYSTEM INSTALLATION
In the following sections, the hardware you will be using
will come from the included plastic parts trees.
Whenever possible, the part will have a number
associated with it and that number will be in
parentheses. For example, the Z-bend clevis part
number is A1 on the parts tree.
Install the Servos & Pushrods
❏ ❏
1. Carefully remove the film covering the servo bays
just behind the wings. Insert a servo with the spline toward
the tail as shown on both sides of the fuselage.
❏ ❏
2. Glue the servo in place using medium CA.
❏ ❏
3. Insert a Z-bend clevis (A1) into a control horn
(B1) as shown. It may be necessary to slightly enlarge the
hole in the control horn (B1) to allow the Z-bend clevis (A1)
to rotate freely. If necessary, use a sharp hobby knife to
enlarge the hole.
❏ ❏
4. Glue the control horn (B10) in place using medium
CA as shown. Press a backplate (B2) onto the back side of
the control horn (B1).
❏ ❏
5. Install a Z-bend clevis (A1) in the last hole out on the
servo arm. If needed, enlarge the hole in the servo arm slightly
with a sharp hobby knife prior to attaching it to the servo.
❏ ❏
6. Center all trims on your radio system and connect
the rudder servo to the rudder channel to center the servo.
Attach a servo arm (G6) as shown.
❏ ❏
7. Locate a 12" [305mm] carbon rod and one pushrod
standoff (E3).
❏ ❏
8. Slide one pushrod stand off onto the 12" [305mm]
carbon rod. Insert the pushrod into both Z-bend clevises
(A1) as shown. If necessary, lightly sand the carbon rod. Be
careful when inserting it into the clevis.
9