GREAT PLANES Riot 3D Gebruiksaanwijzing - Pagina 9

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} GREAT PLANES Riot 3D. GREAT PLANES Riot 3D 20 pagina's.

RADIO SYSTEM INSTALLATION

In the following sections, the hardware you will be using

will come from the included plastic parts trees.

Whenever possible, the part will have a number

associated with it and that number will be in

parentheses. For example, the Z-bend clevis part

number is A1 on the parts tree.

Install the Servos & Pushrods

❏ ❏

1. Carefully remove the film covering the servo bays

just behind the wings. Insert a servo with the spline toward

the tail as shown on both sides of the fuselage.

❏ ❏

2. Glue the servo in place using medium CA.

❏ ❏

3. Insert a Z-bend clevis (A1) into a control horn

(B1) as shown. It may be necessary to slightly enlarge the

hole in the control horn (B1) to allow the Z-bend clevis (A1)

to rotate freely. If necessary, use a sharp hobby knife to

enlarge the hole.

❏ ❏

4. Glue the control horn (B10) in place using medium

CA as shown. Press a backplate (B2) onto the back side of

the control horn (B1).

❏ ❏

5. Install a Z-bend clevis (A1) in the last hole out on the

servo arm. If needed, enlarge the hole in the servo arm slightly

with a sharp hobby knife prior to attaching it to the servo.

❏ ❏

6. Center all trims on your radio system and connect

the rudder servo to the rudder channel to center the servo.

Attach a servo arm (G6) as shown.

❏ ❏

7. Locate a 12" [305mm] carbon rod and one pushrod

standoff (E3).

❏ ❏

8. Slide one pushrod stand off onto the 12" [305mm]

carbon rod. Insert the pushrod into both Z-bend clevises

(A1) as shown. If necessary, lightly sand the carbon rod. Be

careful when inserting it into the clevis.