Emergi-Lite HP Series Manual

Browse online or download pdf Manual for Camera Accessories Emergi-Lite HP Series. Emergi-Lite HP Series 4 pages. Battery unit for hazardous locations

Print Page
HP Series
Battery Unit for hazardous locations
Class 1, Division 2, Class II, Division 1 & 2, Groupe E, F & G
Risk of Electrical Shock.
Disconnect Power before Installation.

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1.
Servicing of this equipment should be performed by qualified service
personnel.
2.
All unused wires must be insulated to prevent shorting.
3.
Turn off electrical power before and during installation and maintenance.
4.
Keep tightly closed when in operation.
5.
Use caution when handling batteries. Battery acid can cause burns to the
skin and eyes. If acid is spilled on the skin or eyes, flush affected area
with fresh water and contact a physician immediately.
6.
Avoid possible shorting.
7.
Equipment should be mounted in locations and at heights where it will
not readily be subjected to tampering by unauthorized personnel.
8.
The use of accessory equipment not recommended by the manufacturer
may cause an unsafe condition.
9.
Do not use this equipment for other than intended use.
10.
Unit to be installed only as per configuration described in this instruction
manual.
SAVE THESE INSTRUCTIONS
Installation Instructions
1. Turn off unswitched AC power.
2. Open the cover (See figure 1).
3. For units with remote emergency lighting: remove the bushing located on
the side of the unit and install the conduit fitting rated for Class 1 Div 2
(provided) into the open hole for DC wires.
Wall mount
Install the unit on the wall with 4 screws (not included). 
Column mount (option)
a. The universal mounting bracket is an accessory ordered separately
(See figure 2).
b. The bracket can be installed using steel banding for routing around
the column. Standard banding (not provided) must be maximum 3/4-
inch in width. The bracket can also be mounted on a Superstrut®
metal framing (1 5/8-in channel series) using 1/4-in bolts (not
provided). Holes are placed at 9-in apart horizontally.
c. Install the bracket, observing the indicator: TOP.
d. Slide the unit into the tabs located on both sides of the unit until it sits
on the bottom lip of the bracket (See figure 2).
e. Screw the unit onto the bracket with the 4 screws, washers and nuts
included in the bracket kit.
4. A pre-installed conduit fitting rated for Class 1 Div 2 is located on the top
of the unit.
Emergi-Lite®
Tel: (888) 552-6467
®
WARNING:
HP Series Battery Unit for hazardous locations
Housing
Battery(ies)
Charger
module
Lamps
Figure 1
Slide housing into
mounting bracket.
Screw the unit to the
mounting bracket.
Figure 2
WARNING:
Fax: (800) 316-4515
www.emergi-lite.com
Conduit
entries(2)
Transformer
Pilot light and
Infrared test switch
Ensure housing
is aligned with
Couduit
the tabs
entries(2)
and slide down.
THE COLUMN MUST BE
ANCHORED TO THE FLOOR
AND CEILING.
11/17 750.0020 Rev. A
1/4