DaytonAudio HTA20 User Manual - Page 5

Browse online or download pdf User Manual for Amplifier DaytonAudio HTA20. DaytonAudio HTA20 8 pages. 20w integrated stereo hybrid tube amplifier

Print Page

1. Source Selector

Turn this knob to select between different sources.

2. Volume Knob

Turn this up to begin experiencing the warm natural tone generated by the tube

preamplifier.

3. Bluetooth Antenna

During setup, turn the Bluetooth antenna to the upright position for optimum

signal reach.

4. Line Level Aux Inputs

5. PC-USB Input

6. Subwoofer Output

Use a single RCA cable to connect the S.W. OUT to a powered subwoofer or

separate subwoofer amplifier.

This will output a full range mono signal and the volume output will change

depending on the position of the front panel volume control.

NOTE: The output will signal will be interrupted when headphones are connected

on the front of the amplifier.

7. Speaker Outputs

Using insulated 2 conductor wire to connect to speakers. The polarity, positive

(+), and negative (-) for all speaker and amplifier connections must be consistent

so both the left and right speakers are in phase.

NOTE: The speaker outputs are not bridgeable.

8. Power Switch

Turns the device on and off.

9. AC Power Input

10. Headphone Output

The headphone output allows you to listen to any input privately without playing audio

through your speakers. The output accepts ¼" TRS headphone connectors. Plugging

in headphones here will cut off the signal to the speakers and S.W. OUT [6].

NOTE: To avoid accidental damage to your headphones or speakers always turn

down the volume before connecting or disconnecting headphones.