DaytonAudio HTA20 Podręcznik użytkownika - Strona 5
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wzmacniacz DaytonAudio HTA20. DaytonAudio HTA20 8 stron. 20w integrated stereo hybrid tube amplifier
Drukuj stronę
1. Source Selector
Turn this knob to select between different sources.
2. Volume Knob
Turn this up to begin experiencing the warm natural tone generated by the tube
preamplifier.
3. Bluetooth Antenna
During setup, turn the Bluetooth antenna to the upright position for optimum
signal reach.
4. Line Level Aux Inputs
5. PC-USB Input
6. Subwoofer Output
Use a single RCA cable to connect the S.W. OUT to a powered subwoofer or
separate subwoofer amplifier.
This will output a full range mono signal and the volume output will change
depending on the position of the front panel volume control.
NOTE: The output will signal will be interrupted when headphones are connected
on the front of the amplifier.
7. Speaker Outputs
Using insulated 2 conductor wire to connect to speakers. The polarity, positive
(+), and negative (-) for all speaker and amplifier connections must be consistent
so both the left and right speakers are in phase.
NOTE: The speaker outputs are not bridgeable.
8. Power Switch
Turns the device on and off.
9. AC Power Input
10. Headphone Output
The headphone output allows you to listen to any input privately without playing audio
through your speakers. The output accepts ¼" TRS headphone connectors. Plugging
in headphones here will cut off the signal to the speakers and S.W. OUT [6].
NOTE: To avoid accidental damage to your headphones or speakers always turn
down the volume before connecting or disconnecting headphones.
5