Greatneck 80134 Operating Instructions And Parts Manual - Page 5

Browse online or download pdf Operating Instructions And Parts Manual for Power Tool Greatneck 80134. Greatneck 80134 8 pages.

Print Page

Operating Instructions and Parts Manual

ASSEMBLY & OPERATION

SPEED SELECTION

Set Rotary Tool speed by rotating the variable speed

control dial (1) to the appropriate speed (see Fig.1).

Position the speed control dial at "1" for slowest

speed, "3" for medium speed and at "MAX" for the

highest speed.

Fig. 1

ON/OFF SWITCH

To turn the switch ON, push on the lower part of the

ON/OFF switch (1) (see Fig. 2). To turn the switch OFF,

push on the upper part of the ON/OFF switch (2).

Fig. 2

CHANGING THE COLLET

Some accessories require the use of different sized

collets. Collet sizes can be 1/16", 3/32" and 1/8". It is

important to ensure that the collet size matches the

accessory.

NOTE: This tool includes two of the most commonly

used collets: 3/32" and 1/8".

WARNING

Using a collet that is too large for the accessory will

result in the accessory possibly being thrown from the

tool causing serious injury.

1. Turn the tool switch OFF and remove the plug from

the power source.

2. Depress the spindle lock button (1) and slowly turn

the collet nut (2) until the spindle lock button locks

the spindle. (see Fig. 3)

3. While holding the spindle lock button down, turn

the collet nut counter clockwise until it is removed.

4. Remove the collet (3) by pulling it out of the

spindle (4).

06/15

2015 GREATNECK

5. Insert the replacement collet into the spindle and

replace the collet nut by turning it clockwise while

holding the spindle lock button down.

NOTE: Do not tighten the collet nut without an

accessory installed in the collet. You will damage the

collet.

Fig. 3

INSTALLING ACCESSORIES

1. Turn the switch OFF and disconnect the tool from

the power source.

2. Depress the spindle lock button (1) and slowly turn

the collet nut (2) until the spindle lock button locks

the spindle.

3. While holding the spindle lock button down, turn

the collet nut counter clockwise until the collet is

loose inside the collet nut.

Fig. 4

4. Insert accessory (3) into collet.

NOTE:

a) Make sure the correct collet is used for the

accessory. If collet is too large, replace the collet

with the next smaller size.

b) Insert accessory at least 3/4" into the collet.

5. Press the spindle lock button and engage it

in the spindle. While holding the spindle lock

button down, hand tighten the collet by turning it

clockwise.

NOTE: Do not use pliers to tighten the collet nut. Use

the small wrench (4) supplied. Over tightening will

cause damage to the tool.

6. Pull on the accessory to ensure it is securely in

place.

80134

ROTARY TOOL