Hickory Industries Rotisseries N/1.9E Installation And Owners Operating Manual - Page 3

Browse online or download pdf Installation And Owners Operating Manual for Grill Hickory Industries Rotisseries N/1.9E. Hickory Industries Rotisseries N/1.9E 14 pages.

Print Page

INSTALLATION INSTRUCTIONS

Barbecue products are often bought on impulse. The 1.9E been designed for maximum viewing by both

the customers, as well as the operator. The unit has glass surfaces, on top, front and on both sides. It should

be placed where it will get the best and most exposure. Wherever the unit is placed, remember that the

operator will need continual access through the hinged glass door. If placed on a counter, table, or case,

care should be taken to secure the unit so that it cannot be dislodged. The N/1.9e has been designed for

wall mounting and an additional kit is available for that purpose.

WARNING: THIS MACHINE IS AN OVEN AND SHOULD NEVER BE PLACED WITHIN

PUBLIC ACCESS. FOLLOW MINIMUM CLEARANCE REQUIREMENTS

FOR ALL UNITS AS PER SPECIFICATION GUIDES.

ASSEMBLING THE MACHINE:

The 1.9E needs minimal assembly. The glass panels are all packed separately and must be properly

positioned prior to use. The spits are individually packed. Check all parts and accessories and compare it

to your packing list. Remove all tape on glass, and vinyl coating on stainless steel.

ELECTRICAL HOOK UP:

The N/1.9e must be electrically connected to a hard wired circuit by a licensed electrician. Your

machine is wired single phase or three phase, 208V/220V or 240V, depending on how it was ordered. The

electrical power connections are made in the junction box which can be found by removing the operating

side panel. Each junction position is marked as 1, 2, 3, N and G.

WARNING: IF CONNECTIONS ARE MADE INCORRECTLY, IT IS POSSIBLE TO

BURN OUT DRIVE MOTORS, FAN MOTORS AND COMPUTER CONTROL

CIRCUITS.

The electrical components on the N/1.9e require less than 20amps at 208v.

VENTING:

Follow all local codes and requirements and/or ANSI standards

4900 Westside Avenue, North Bergen, New Jersey 07047

Tel: [201] 223-0050 Fax: [201] 223-0950

Hickory Industries, Inc.

1.9 Manual 10/97

Page 3 of 14