Hickory Industries Rotisseries N/1.9E Instrukcja instalacji i obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla grill Hickory Industries Rotisseries N/1.9E. Hickory Industries Rotisseries N/1.9E 14 stron.
Drukuj stronęINSTALLATION INSTRUCTIONS
Barbecue products are often bought on impulse. The 1.9E been designed for maximum viewing by both
the customers, as well as the operator. The unit has glass surfaces, on top, front and on both sides. It should
be placed where it will get the best and most exposure. Wherever the unit is placed, remember that the
operator will need continual access through the hinged glass door. If placed on a counter, table, or case,
care should be taken to secure the unit so that it cannot be dislodged. The N/1.9e has been designed for
wall mounting and an additional kit is available for that purpose.
WARNING: THIS MACHINE IS AN OVEN AND SHOULD NEVER BE PLACED WITHIN
PUBLIC ACCESS. FOLLOW MINIMUM CLEARANCE REQUIREMENTS
FOR ALL UNITS AS PER SPECIFICATION GUIDES.
ASSEMBLING THE MACHINE:
The 1.9E needs minimal assembly. The glass panels are all packed separately and must be properly
positioned prior to use. The spits are individually packed. Check all parts and accessories and compare it
to your packing list. Remove all tape on glass, and vinyl coating on stainless steel.
ELECTRICAL HOOK UP:
The N/1.9e must be electrically connected to a hard wired circuit by a licensed electrician. Your
machine is wired single phase or three phase, 208V/220V or 240V, depending on how it was ordered. The
electrical power connections are made in the junction box which can be found by removing the operating
side panel. Each junction position is marked as 1, 2, 3, N and G.
WARNING: IF CONNECTIONS ARE MADE INCORRECTLY, IT IS POSSIBLE TO
BURN OUT DRIVE MOTORS, FAN MOTORS AND COMPUTER CONTROL
CIRCUITS.
The electrical components on the N/1.9e require less than 20amps at 208v.
VENTING:
Follow all local codes and requirements and/or ANSI standards
4900 Westside Avenue, North Bergen, New Jersey 07047
Tel: [201] 223-0050 Fax: [201] 223-0950
Hickory Industries, Inc.
1.9 Manual 10/97
Page 3 of 14