Gainlab Audio GL-TC1 Manual - Page 10
Browse online or download pdf Manual for Recording Equipment Gainlab Audio GL-TC1. Gainlab Audio GL-TC1 16 pages. Dictator stereo vari-m compressor
Print Page
!
POWER SWITCH
mains, if you want to disconnect the device completely from the mains, unplug the
device from the mains or switch off the main switch at the IEC socket !
GROUND LIFT
!
DICTATOR STEREO VARI-μ COMPRESSOR
The unit is switched on with the switch marked POWER. Set
the switch labeled POWER to the up position if you want to
turn on the unit. Set the switch labeled POWER to the down
position when not in use.
Due to the tube design of the device, it is advisable to leave
a "warm-up time" of 15-20 minutes before starting use.
ATTENTION! the switch labeled POWER puts the device in
standby mode, does not completely disconnect it from the
The switch on the back of the device allows the outgoing
audio connection to be disconnected from ground, thus
eliminating ground loop phenomena that occur under
certain conditions. To adjust the ground defrost, set the
GROUND LIFT switch on the rear panel to the up position.
! 9