Dynamic Controls DX-ACC2 Installation Manual - Page 6

Browse online or download pdf Installation Manual for Control Unit Dynamic Controls DX-ACC2. Dynamic Controls DX-ACC2 7 pages. Drive stop module

Print Page

International Standards

Dynamic Controls products built today allow our customers' vehicles to conform

to national and international requirements. In particular to:

ISO7176-9

ISO7176-14

ISO7176-21

However the performance of controllers fitted to wheelchairs and scooters is very

dependent on the design of the scooter or wheelchair so final compliance must be

obtained by the vehicle manufacturer for their particular vehicle. No component

compliance certificate issued by Dynamic Controls relieves a wheelchair/scooter

manufacturer from compliance testing their particular vehicles.

User manuals should contain EMC warnings along the following lines:

Most electronic equipment is influenced by Radio Frequency

Interference (RFI). Caution should be exercised with regard to the use

of portable communications equipment in the area around such

equipment. While the manufacturer has made every effort to ensure

that RFI does not cause problems, very strong signals could still cause

a problem. If RFI causes erratic behaviour, shut the wheelchair off

immediately. Leave off while transmission is in progress.

- Climatic Tests for Electric Wheelchairs

- Power and Control Systems for Electric Wheelchairs

- Requirements and test Methods for Electromagnetic

Compatibility of Electric Powered Wheelchairs and

Scooters.

DX Drive Stop Module, March 2003