ADEMCO Vista-20HWSE/SE Quick Manual - Page 2

Browse online or download pdf Quick Manual for Control Panel ADEMCO Vista-20HWSE/SE. ADEMCO Vista-20HWSE/SE 4 pages.

Print Page
ADEMCO Vista-20HWSE/SE Quick Manual
Battery
The Ademco Vista – 20HWSE/SE operates on a 12V battery.
A low battery condition or a loss of AC power and use of backup battery power is indicated by BAT,
LOW BATT or SYSTEM BATTERY FAILURE
For instructions on replacing your battery, please visit our
Bypassing Protected Areas
Bypassing a zone allows you to arm your system with certain protected areas intentionally unarmed.
To bypass a zone, press [security code] + [6] + [zone number].
Wait until the panel displays "BYPASS".
To unbypass a zone, disarm the system.
Chimes and Beeps
When your system is in chime mode, a chime alert will sound three tones whenever a protected door/window
is opened.
To turn chime mode on and off, enter your [security code] + [9].
Reset
To clear the display after an alarm event, enter your [security code] + [1].
Security Codes
You can program up to 14 additional users, however only the Master user can assign user codes to users.
Note that user numbers 1 and 2 are already assigned to the Installer and the Master user, respectively.
To add a new user, enter the [Master code] + [8] + [new user number] + [new user's code].
To delete a user, enter the [Master code] + [8] + [user number].
Wait approximately 3 seconds until the keypad beeps once to verify the user has been deleted.
Battery Replacement Page.