DBK Drymatic Boost Bar FGPH109 Instruction Manual - Page 8

Browse online or download pdf Instruction Manual for Dryer DBK Drymatic Boost Bar FGPH109. DBK Drymatic Boost Bar FGPH109 16 pages. Adaptable heat drying system
Also for DBK Drymatic Boost Bar FGPH109: Instruction Manual (18 pages)

Print Page
4. Set the desired temperature and start the machine
The main screen on the Drymatic Boost Bar control panel can be used to operate the machine (Start/Stop), view the current
operating conditions and graphed data. The settings button on the bottom right of the display allows the user to set the
maximum temperature limit, maximum current limiter, change the language, and reset the unit ready for the next job:
Machine Status Indicating:
Machine Running
Machine Stopped
NTC Readouts for Air In and Air Out
Machine to detect direction of
airflow (Warmest NTC)
Drymatic Boost Bar has five control buttons along the bottom of the screen; Start, Stop, Graphical Data, Pin Lock, and Settings.
The top ribbon shows the machine status; in any situation where the machine is stopped the Start button will restart it from
where it previously left off. Similarly the Stop button will put the machine on hold without the need to power it down. In order
to correctly understand how the reset button functions, please see 'About the Memory' section. The Settings button on the
bottom right of the display takes the user to a new screen and allows them to set the maximum temperature, maximum
current limit, reset the device and change the language and units. This settings screen and description of each function is
shown below:
User Set Maximum
Temperature (Inlet)
User Set Maximum
Current
Press to change
between °C and °F
Accept Changes
Live Power Readout
Main Screen:
F
F
Start Machine Stop Machine
Go to Graph Screen
Settings Screen:
Cancel Changes
Reset kWH and hours on main screen
(not life total)
Airflow Indicator (Airflow Detected)
Separate Icon for no airflow
Heater Power Level
(One per relay)
Total Hours Run and kWh
Readouts. Values stored
even during power loss
Lock Machine
Go to Settings Screen
Language, press to change between
English, Spanish, French and German
Enter Factory Configuration Mode
View Regulatory Information
Life run data (cannot be reset)
Machine Serial #