CellarPro 3200 Series Owner's Manual - Page 8

Browse online or download pdf Owner's Manual for Freezer CellarPro 3200 Series. CellarPro 3200 Series 9 pages. Cooling systems

Print Page

Option and Upgrades

Front Duct Kit:

Rear Duct Kit:

Rear Duct Kit with Fan:

Bottle Probe:

Crankcase Heater:

Air Filters:

Custom duct hood allows the cold air intake/exhaust to be ducted

up to 100 equivalent feet (50 feet per opening). Duct openings are

designed to attach to two 8" ducts for condenser intake and

exhaust. Design allows easy access to cooling unit controls;

requires an additional 9" of height at the front of the unit. Kit

includes duct hood and 50 feet (2x25) of 8-inch insulated (R-6)

ducting.

Custom duct hood allows the hot air intake/exhaust to be ducted

up to 100 equivalent feet (50 feet per opening). Duct openings are

designed to attach to two 8" ducts for condenser intake and

exhaust.

Removable slot plate provides easy access to

removable air filter. Kit includes duct hood and 50 feet (2x25) of 8-

inch insulated (R-6) ducting.

Custom duct hood and inline fan allow the hot air intake/exhaust to

be ducted up to 200 equivalent feet (100 feet per opening). Duct

openings are designed to attach to two 8" ducts for condenser

intake and exhaust. Removable slot plate provides easy access

to our air filter. Inline fan receives switched power from the cooling

unit. Kit includes duct hood, 240 CFM 8-inch inline fan and 50

feet (2x25) of 8-inch insulated (R-6) ducting.

CellarPro 3200 cooling units are designed to cycle on and off

based on the temperature of the return air in the wine cellar.

Because the cooling unit is located near the top of the cellar, it will

cycle based on the temperature of the air at the top of the cellar,

which is by design given that warm air rises. However, for

instances when the wine cellar is unevenly shaped and/or the

cooling unit cannot be mounted near the ceiling, it may be useful

to use a bottle probe for determining the on/off cycle of the cooling

unit. In addition to being able to accommodate bottle probes,

CellarPro cooling units can be programmed to have a tighter

temperature differential, so that wine temperature variations

remain in a tight band.

When the cooling unit is exposed to temperatures below 40°F, the

refrigerant in the compressor can migrate into the crankcase oil

when the compressor is not running. On startup, this can cause

excessive motor wear and a loss of refrigeration efficiency. Our

self-regulating

crankcase

compressor and provides reliable peak heating during critical cold

periods down to 20°F, and reduces its heating once the

compressor starts up or the air temperature rises.

We sell replacement fiberglass filters (interior use only), as well as

aluminum air filters that can be used in interior or exterior

environments.

The aluminum filter is reusable and can be

cleaned with steam or hot water spray. Filters meet UL Class 2

flame retardance requirements. Maximum temperature is 240°F.

heater

wrapped

Table IV

around

the