ADENDORFF MAC AFRIC SDRILC-005 Original Operating Instructions - Page 10
Browse online or download pdf Original Operating Instructions for Power Screwdriver ADENDORFF MAC AFRIC SDRILC-005. ADENDORFF MAC AFRIC SDRILC-005 14 pages. Cordless brushless driver/hammer drill
Print Page
Tightening Bolt
CAUTION:
1. Set the tap position at the low speed.
Nominal Diameter
of Wood Screw （mm）
3.1
3.5
3.8
4.5
4.8
5.1
5.5
5.8
6.1
2. Make sure that the driver bit is inserted
vertically in the bolt head, or the bolt or the
bit may be damaged.
3. Please choose suitable torque according to your operational need.
To tighten bolt, hammer the point of the driver bit at the bolt head and force the tool properly.
Switch on the tool slowly and then speed it
up gradually. Once the clutch is closed,
release the switch trigger. (Fig 14)
When tightening wood screws, drill a center
hole first to make tightening action much
easier and to prevent workpiece from
sliding. Please refer to the following sheet:
Recommended Size
of Center Hole（mm）
2.0-2.2
2.2-2.5
2.5-2.8
2.9-3.2
3.1-3.4
3.3-3.6
3.7-3.9
4.0-4.2
4.2-4.4
Removing Bolt
To remove the bolt, hammer the point of the
driver bit at the bolt head and force the tool
properly. Switch on the tool slowly and then
speed it up gradually. Once the bolt is taken out,
release the switch trigger. (Fig 15)
Spindle Locking
CAUTION:
Do not press the switch trigger forcibly when the tool is used as hand tool, or the tool will be
damaged.
When the switch trigger is not pressed, the drill spindle is locked. This enables screws to be
screwed in even when the battery runs out and allows the tool to be used as hand tool.
Over-load Protection
The motor will stop running when it is overloaded. To restart the tool, release the switch
trigger first to reset the switch and then switch on the machine
Overheated Protection
When using as intended for, the tool cannot be subject to overload. When the load is too high
or the allowable battery temperature of 75℃ is exceeded, the electronic control will shut off
the tool until the temperature is in the optimum temperature range again.
Deep Discharging Protection
The tool is equipped with a protective circuit to protect the battery against deep discharging.
When the battery is near to be empty, the protective circuit actuates to switch off the tool.
Disposing of Battery Cartridge
Lithium ion battery is contained in the battery cartridge. For environmental protection,
recycle or dispose of the worn out battery properly. Please consult with your local relevant
departments about how to recycle and/or dispose of the worn out battery.
To recycle or dispose of the worn out battery: