909 20VHTG Instruction Manual - Page 11

Browse online or download pdf Instruction Manual for Trimmer 909 20VHTG. 909 20VHTG 16 pages.

Print Page

Fitting and removing the battery pack

To remove the battery pack

from the tool firmly press

the battery release button at

the back of the battery pack

and slide the battery pack

backward, and then pull or

lift the battery out of the tool

handle.

To install the battery pack

into the tool, align the rails of

the battery pack with the rails

in the tool and push the battery into the housing. To connect

the battery, slide the battery pack fully forward.

Battery charging

IMPORTANT.

Before plugging in

the power supply from the plug

pack charger (7) always ensure

that the plug is switched off at

the mains.

IMPORTANT.

The battery will be

fully charged after approx 3–5

hours: remove it from the charger

after this time.

Do not leave a battery charging

for longer than 24 hours.

1. Connect the plug pack charger (7) to a mains power

outlet (240Vac).

2. Insert the plug pack charger (7) lead into the back of the

battery.

3. Turn on the plug pack charger. The red indicator on the

battery pack will glow red indicating power is available

at the battery pack. If the battery is charging the green

indicator light will illuminate. The red light will always

glow red when the charger is connected and power is

available.

4. When the battery is charged, the green light will no longer

glow. The battery is now fully charged.

20VHTG IM ed6.indd 11

Note:

You do not have to wait for a full charge of the

battery to use it on the tool. The battery may be used on

the tool as long as there is some charge in the battery.

CAUTION:

If using the battery in a semi-charged state

after a period of charging be sure to remove the battery

from the plug Pack charger. DO NOT use the Battery on

the tool if it is connected to the plug pack charger.

To obtain the best life for the battery

Never allow the tool to completely drain the battery and

come to a complete stand still before recharging. The

battery should be placed on charge whenever the battery

is noticeably running down or the tool no longer performs a

task it previously performed. For storage, charge between

50 and 75%. Avoid allowing loose items like screws or nails

etc. to be stored with battery packs as these or similar items

can short battery packs and cause a fire or explosion.

Always unplug the charger when not in use and store in

a dry secure place.

Avoid charging or storing your battery in temperatures

below 0ºC and above 40ºC.

28/8/13 8:10:03 AM