Autopage MA-200 Operation Manual - Page 6

Browse online or download pdf Operation Manual for Security System Autopage MA-200. Autopage MA-200 13 pages. 2-way remote control motorcycle alarm
Also for Autopage MA-200: Installation Instructions Manual (8 pages)

Print Page

Enter Valet Mode:

1. From the disarmed condition, turn the ignition to "ON" position.

2. Push and hold valet switch for 2 seconds until the LED turns on. The LED will

remain on as long as the system is in 'valet mode'.

Exit Valet Mode:

1. Return to normal operation, turn ignition 'ON'.

2. Push and hold valet switch for 2 seconds; The LED will turn off, indicating that the

system has exited the valet mode.

REMOTE VALET: (System in Disarm or Valet mode)

Press and release the

button three times within 3 seconds to enter / exit valet mode.

A parking lights flash will confirm entering the valet mode.

Two parking lights flashes will confirm exit.

L. MOTORCYCLE LOCATOR:

Press the

button on the 5-button 2-way transceiver in armed mode to activate the motorcycle locator

function. The siren will chirp 6 times and the parking lights will flash 12 times, for you to easily locate your

motorcycle.

M. PANIC FUNCTION:

The transmitter can be used as a remote panic switch to manually trigger the alarm in

case emergency. To activate the panic mode, press and hold

transmitter for 3 seconds. The siren will sound and continue for 30 seconds or until the

button is activated a second time.

N. TRIGGER THE SYSTEM

When armed, your motorcycle is protected as follows:

1. Light impacts will trigger the warn-away signal. A long chirp from siren/horn.

2. Heavy impacts will trigger the system. The full trigger sequence is 30 seconds of constant siren and

flashing parking lights.

3. If the tilt switch is triggered / the closed loop wires of the connection are not in contact / the ignition is

turned on while the system is armed, the full trigger sequence will activate.

4. The starter kill prevents the motorcycle's starter from cranking.

Activated on the

Tilt Sensor

Close Loop

Clear The Flash Icon And Melody Sound: While triggering the alarm, the LCD screen will alert the user

through melody sound and flashing trigger icon. Pressing the

clear the flash icon and stop the melody sound on the LCD screen transceiver.

Stop The Melody Sound Only: While triggering the alarm the LCD screen will alert user through melody

sound and flashing trigger icon. Press any button on the LCD remote transceiver to stop melody sound

only.

NOISE ABATEMENT CIRCUIT:

repetitive trigger sequences due to faulty sensor or environmental condition such as thunder,

jackhammers, airport noise, etc.

Here's how "Noise Abatement Circuit" works: The alarm triggers five times. Each time, the same sensor or

switch is triggering the alarm. "Noise Abatement Circuit" will interpret this pattern of triggers as false alarm.

After the fifth trigger, "Noise Abatement Circuit" ignores, or by- passes that sensor or switch until the other

sensor or switch is triggered.

MA-200 OP REV.A

Activated on the

Shock Sensor

Ignition Switch

button 3 times within 3 seconds will

Your system has "Noise Abatement Circuit". It prevents annoying

Oct/23/2006

button of your

Warn-away

Trigger