Autopilot APCECOD Manual - Page 11

Browse online or download pdf Manual for Controller Autopilot APCECOD. Autopilot APCECOD 17 pages. Deluxe digital co2 controller

Print Page

Page 10

APCECOD

Q & A

How can I tell if my CO2 reading is accurate? You can check

the calibration of the CO2 sensor by placing the sensor outdoors

for 30 minutes. It should read close to 380 PPM. *See the HOW

TO calibrate section.

When I turn on power, the unit says CO2 heat? This is normal,

it takes 5 minutes for the sensor to warm up.

SEn? The remote probe is not

Why is the display reading

Err

connected and/or communicating with the controller. Check the

quick-connect cable and that the remote probe is getting power.

*Contact the factory for more info.

What if the of the small green Error LEDs are on? The CO2

sensor or CO2 device is not acting correctly. Refer to the Error

LEDs sections to diagnose the problem.

Why isn't the CO2 outlet turning on? Verify the correct CO2

mode has been selected and/or verify the photocell daytime

green led is turned ON.

What if there is no power? Reset the power switch (circuit

breaker).