Autoplugin Key-V2 User Manual - Page 3

Browse online or download pdf User Manual for GSM/GPRS Modules Autoplugin Key-V2. Autoplugin Key-V2 8 pages.

Print Page

Description

The Autoplugin Key-V2 is an electronic module designed to add a remote control

ability to the fuel-fired heater (parking heater, fuel operated heater, pre-heater),

factory installed in Volvo S60 (2010-2018), V60 (2010-2018), V70 (2007-2016),

XC70 (2007-2016), S80 (2007-2016) or XC60 (2008-2016). The device is plugged

into the diagnostic socket, placed on the dashboard, and controls the heater via

CAN-bus.

· Immediate start of the heater with Volvo car's key. The remote control

key with 5 buttons or the PCC with 6 buttons can be used for heater

control

· Immediate stop of the heater with Volvo car's key

· Indication of the heater autonomous operation with direction indicators

flashing in rearview mirrors.

· Additional main battery protection from discharging by inspecting of

voltage level and time of the heater autonomous operation

1. Autoplugin Key-V2 cartridge

2. User Manual brochure

The module needs that 2 timers and direct start / stop function for the heater

control are present in the CIP. Therefore it may be necessary to load special

software to the CIP at first by the means of Volvo dealer's equipment.

Check the "Lamp" button of the remote control key switches on the "Approach

lighting". Activate the "Approach lighting" in the MY CAR menu if necessary.

Autoplugin Key does not need professional installation. Find the diagnostic socket

at the left lower point of the dashboard. The socket is placed closer to the bonnet

opening handle. Take the module to your hand in such manner, that the LED is

placed closer to the driver's door side, and then gently push the module to the

socket. LED starts flashing for approximately 10 seconds, waiting for information

from CAN-bus. Wait until the LED stops flashing before the operation. Turn the

ignition on if the LED continues flashing after 10 seconds period expired.