Autoplugin Key-V2 User Manual - Page 5

Browse online or download pdf User Manual for GSM/GPRS Modules Autoplugin Key-V2. Autoplugin Key-V2 8 pages.

Print Page
If the entered digit is not correct, press and release "Read/OK" button until the
module indicates an error. Enter the code once more in that case. Several codes can
be entered without exit of setup mode.
Turn the ignition off to exit from the Setup mode. New settings are saved in the
non-volatile memory of the module and stored there regardless of whether the
module is connected or not. Note: start the engine inside the Setup mode if you
want to exit without saving of new settings.
To reset the module to the factory settings, enter the code 8.1.1. Both direction
indicators in the CIP should flash three times, confirming command execution.
Then the module exits Setup mode and restarts.
* Direction indicators flash in Setup mode only in cars with analogue instrument
panel. For cars with digital instrument panel use LED's indication of the module
for settings change.
Settings
Settings
Group
Item
1.
1.1. Limitation of
Heater
total operational
operation
time of the heater in
time
pre-heat mode
1.2. Limitation of
one-cycle
operational time of
the heater in pre-
heat mode
2.
2.1. "Lock" and
Heater
"Lamp" buttons'
control with
functions for heater
remote
control
control key
2.2. Number of
sequential "Lamp"
button presses for
heater control
5
Possible Values
1.1.1 *Not adjusted
1.1.2 40 minutes
1.1.3 50 minutes
1.1.4 60 minutes
1.1.5 70 minutes
1.1.6 80 minutes
1.1.7 90 minutes
1.1.8 100 minutes
1.1.9 120 minutes
1.2.1 10 minutes
1.2.2 15 minutes
1.2.3 20 minutes
1.2.4 25 minutes
1.2.5 30 minutes
1.2.6 40 minutes
1.2.7 50 minutes
1.2.8 *Not adjusted
2.1.1 *"Lock" button for the heater start,
"Lamp" button for the heater stop
2.1.2 "Lamp" button for the heater start,
"Lock" button for the heater stop
2.2.1 Combination is disabled
2.2.2 *Four presses
2.2.3 Six presses
2.2.4 Eight presses
Settings table (1)